Blue-angel-pumps ODS10 User Manual download pdf (Page 2)

www.seewaterinc.com or www.oilsmart.org

951.487.8073 • 888.733.9283 • Email: info@seewaterinc.com

121 North Dillon Street • San Jacinto, CA 92583

P.O. Box 1269 • San Jacinto, CA 92581

Fail-Safe Technology since 1995.

OIL SMART® SWITCH AND PUMP

INSTALLATION:

CAUTION: YOU MUST REMOVE ANY

FLOAT SWITCH THAT IS CURRENTLY IN

USE OR SUPPLIED BY PUMP

MANUFACTURER. IF PUMP HAS

MANUAL/AUTO SET, SWITCH TO

MANUAL.

Installation of the Oil Smart® water pump

switch allows you to comply with State and

Federal regulations while reducing the risk

of adverse publicity, fines and expensive

cleanup costs. The Oil Smart® water

pump switch prevents inadvertently

pumping oil contaminated waste into the

environment, improves the reliability of your

electric system and provides a safe, dry

work environment for your employees.

FUSING:

Follow the pump manufacturer's

instructions. Do not exceed the Oil Smart®

switch amp rating. A portable devise may

not be attached to a permanent

structure.

THE INITIAL INSTALLATION:

should be in a clean environment, clear of

mud and all metallic debris. The switch

should be installed where the water

intrusion will not directly contact or splash

the switch body.

Mud and other conductive materials left on

the body of the switch will hamper its

operation. Effort must be taken to clean the

switch prior to leaving initial installation.

CLEAN STRUCTURE:

requires minimum switch maintenance for a

trouble-free operation. Install the switch so

that on and off sensors clear any metallic

material (earth, mud, concrete and all

metals) by a minimum of 2".

SWITCH MAINTENANCE:

The white plastic case must be clean of any

conductive materials (dirt, soap or rust).

Clean with alcohol.

OPERATION:

Normal Condition (Water Only)

The short sensor probe turns the pump "on"

and the long sensor probe turns the pump

"off". When the short sensor is in contact

with water, the pump will continue to cycle

"on and off" until the short sensor detects

oil.

Oil Present Condition

The pump will not cycle if oil is in contact

with the short sensor.

High Water (Oil Present Condition)

If additional water enters the basin, it will

cause the oil layer to rise above the short

sensor, resulting in the pump cycling.

OIL SMART

®

WATER PUMP SWITCH

WATER

WATER

OIL

LAYER

WATER

OIL

LAYER

WIRING DIAGRAM

PUMP

OIL

SMART®

SWITCH

AC

VOLTAGE

SOURCE

BROWN

BLACK

WHITE

FUSE

Printed in U.S.A.

"OFF"

"ON"

1 2 3 4

Comments to this Manuals

No comments